For the second post of my blog-a-day week I’ll share what I consider one of the loveliest spots near Waterloo, the crossing of the Conestogo River on Three Bridges Road. Located just west of St. Jacobs and a short drive from where I work, it’s a great spot to go during lunch or at the end of the day to grab a few shots.
In the summer, the river is shallow and slow-moving. In the late winter and early spring with a heavy melt, it’s a torrent and the low bridge is lost completely beneath the water. Regardless of the seasonal changes, I’m still amazed at how many different types of photos I can get at the same place. It just goes to show that you don’t have to travel far to get great shots (or pretty good shots, at least).
I used a wide range of equipment for these photos. The bodies (Nikon D300s, D7000 and N80, Bronica ETRS) were paired with lenses (Nikon 17-55 f/2.8, Nikon 35 f/1.8, Nikon 60 f/2.8G Micro, Nikon 85 f/1.8G, Tokina 11-16 f/2.8, Tokina 50-135 f/2.8, Sigma 50 f/1.4, Bronica MC 40 f/4, Bronica EII 75/2.8). On the self portraits I used Nikon SB-700 and SB-900 strobes with CLS control.
I’ll give a prize to the person who gets the most correct gear-to-photo matches!
Today’s Oldie-but-Goodie is a fun little ‘portrait’ of an action figure. After reading about some cool lighting setups for defining muscle I wanted to try it out on a real live muscular person. Unfortunately, I am not this person…
The Flash (fittingly) would have to stand in for me. This shot is actually one of the more complicated lighting setups that I’ve done. It uses four flashes in total and each of them is modified. The principle of the lighting is to use a softbox in a ‘tabletop’ position, meaning that it sits directly above the subject pointing straight down. The direction of light causes the muscles to cast strong shadows, adding definition. With just this one light, the shadows are quite strong. Rim lighting or fill lighting can lift the shadows.
For this shot I used the lighting diagram below:
A Lumiquest Softbox LTZ on SB-900 sits directly above the subject (even though in the diagram it’s placed slightly in front) and points down. For rim lighting I use two more strobes. On the right is a SB-700 with a grid spot. On the left is a Metz 48 AF-1 with a grid spot.
For the backround I used a fourth light, an Alienbees B800 with 22″ beauty dish with a diffuser sock placed over it. I’ve had a lot of fun placing this light modifier directly into photos as a creative element in the past.
The SB-900 used for tabletop lighting has a Full CTO gel on it. The Metz 48 AF-1 on the left is gelled with a light blue. In hindsight, the blue was probably unnecessary as it doesn’t look much different from the non-gelled flash (see the highlights on his waist at left and right).
The final shot was with the D300s and AF-S 60mm f/2.8 G Micro at f/13 1/125s ISO 100. The B800 with beauty dish was set to minimum power and is still quite bright at f/13 ISO 100. The tabletop light is at 1/2 power and the two rims are 1/16 power.